I2C Mini Shield

The proto shield I’d wired up for the LCD experiments was getting a bit full and I needed to wire up my rotary sensor board so rather than try and add yet another item to it I thought I’d make a mini shield out of tri-pad board.

This basically consists of a couple of resistors and some pins to attach my sensor board to.

I tried to space out the pins so that the board would balance as well as reducing the possibility it might be plugged in incorrectly.

Leave a Reply

Your email address will not be published. Required fields are marked *

 characters available

Notify me of followup comments via e-mail. You can also subscribe without commenting.